Vehicles

FORD EXCURSION (2000-2005) FORD EXCURSION EDDIE BAUER (2000-2005) FORD F-250, F-350, F-450, F-550, F-650 & F-750 SUPER DUTY TRUCKS (1999-NEWER) FORD F-350 SUPER DUTY TRUCKS (1997)

Placement of Mount

Passenger side floor board, under seat

Drilling Requirements

No - uses existing seat bolts

Seat Configuration

Bucket/bench

Pole

Purchased Separately

Finish

Black Powder Coating

Weight

9.4 lbs.

Dimensions

A = 18.75", B = 5.63", C = 6.4375", D = 13.25" Hole Center = 11.5"

Notes

THERE ARE A TOTAL OF 3 PIECES OF STEEL WELDED TOGETHER THAT MAKE THIS PART Some vehicle bases may limit seat travel

Features

Installs in minutes with no drilling required Step feature allows optimized placement of mount with a minimal amount of intrusion of passenger space

Misc.

Note that in Ford Excursion Limited and Eddie Bauer, the heater duct prevents access to the inner seat stud. Carpeting will have to be lifted and the heat duct cut and plugged. This will prevent air travel to the passenger side right rear. Air will still flow to the rear via other ducts. One Offset Universal Mount step is included with this vehicle base In the Ford Excursion Limited and Eddie Bauer editions, the heater duct prevents access to left seat stud. The mount can be used by removing the carpet and plugging the heater duct. If this is unacceptable, the RAM-VBD-101 can be used as an alternative.