Vehicles

CHEVROLET 1500 C/K - 2WD (1994-1999) CHEVROLET 1500 C/K - 4WD-SELECTOR ON DASH ONLY (1994-1999) CHEVROLET 2500 C/K (1994-2000) CHEVROLET 3500 C/K (1994-2000) CHEVROLET BLAZER K-5 (1993-OLDER) CHEVROLET SILVERADO (1998-OLDER) CHEVROLET SUBURBAN (1994-1999) CHEVROLET TAHOE (1994-1999) GMC SIERRA (1994-1999) GMC YUKON (1994-1999)

Placement of Mount

Across transmission hump

Drilling Requirements

No - uses existing seat bolts

Seat Configuration

Bucket/bench

Pole

Purchased Separately

Finish

Black Powder Coating

Weight

6.4 lbs.

Dimensions

A = 14.5", B = 3.75", C = 5.5", D = 9.5" E = 6.25" Hole Center = 23.13"

Notes

This base may not work with the factory installed center console or with Four Wheel Drive Levers that are on the floor. Drilling may be needed for vehicles with a bench seat. Note that the measurement "D" is 9 1/2". Check your vehicle dimensions prior to purchasing this base. Some models have factory installed accessories that prevent installation. Some vehicle bases may limit seat travel

Features

Installs in minutes with no drilling required. Over the hump design allows for excellent mount placement. For the 1998 Chevrolet Silverado, drilling may be required if vehicle has a bench seat. The base may not work with factory installed consoles or 4WD levers on the floor.